Refine
Year of publication
Document Type
- Article (153) (remove)
Has Fulltext
- yes (153)
Is part of the Bibliography
- no (153)
Keywords
- Euterentzündung (22)
- Logistik (20)
- Milchwirtschaft (20)
- Molkerei (13)
- PPS (7)
- Adsorption (6)
- Betriebsdatenerfassung (6)
- Kostenschätzung (6)
- bovine mastitis (6)
- mastitis (6)
Institute
- Fakultät II - Maschinenbau und Bioverfahrenstechnik (153) (remove)
Parametric study of piezoresistive structures in continuous fiber reinforced additive manufacturing
(2024)
Recent advancements in fiber reinforced additive manufacturing leverage the piezoresistivity of continuous carbon fibers. This effect enables the fabrication of structural components with inherent piezoresistive properties suitable for load measurement or structural monitoring. These are achieved without necessitating additional manufacturing or assembly procedures. However, there remain unexplored variables within the domain of continuous fiber-reinforced additive manufacturing. Crucially, the roles of fiber curvature radii and sensing fiber bundle counts have yet to be comprehensively addressed. Additionally, the compression-sensitive nature of printed carbon fiber-reinforced specimens remains a largely unexplored research area. To address these gaps, this study presents experimental analyses on tensile and three-point flexural specimens incorporating sensing carbon fiber strands. All specimens were fabricated with three distinct curvature radii. For the tensile specimens, the number of layers was also varied. Sensing fiber bundles were embedded on both tensile and compression sides of the flexural specimens. Mechanical testing revealed a linear-elastic behavior in the specimens. It was observed that carbon fibers supported the majority of the load, leading to brittle fractures. The resistance measurements showed a dependence on both the number of sensing layers and the radius of curvature, and exhibited a slight decreasing trend in the cyclic tests. Compared with the sensors subjected to tensile stress, the sensors embedded on the compression side showed a lower gauge factor.
Powder bed-based additive manufacturing processes offer an extended freedom in design and enable the processing of metals, ceramics, and polymers with a high level of relative density. The latter is a prevalent measure of process and component quality, which depends on various input variables. A key point in this context is the condition of powder beds. To enhance comprehension of their particle-level formation and facilitate process optimization, simulations based on the Discrete Element Method are increasingly employed in research. To generate qualitatively as well as quantitatively reliable simulation results, an adaptation of the contact model parameterization is necessary. However, current adaptation methods often require the implementation of models that significantly increase computational effort, therefore limiting their applicability. To counteract this obstacle, a sophisticated formula-based adaptation and evaluation method is presented in this research. Additionally, the developed method enables accelerated parameter determination with limited experimental effort. Thus, it represents an integrative component, which supports further research efforts based on the Discrete Element Method by significantly reducing the parameterization effort. The universal nature of deducting this method also allows its adaptation to similar parameterization problems and its implementation in other fields of research.
Subclinical mastitis in heifers during early lactation affects udder health, future milk production and, therefore, the risk of premature culling. The aim of this cross-sectional study was to identify pre- and post-partum risk factors associated with a high heifer mastitis rate (HMR), and to find out which period (either pre- or post-partum) contains more risk factors and consequently should be the focus of mastitis control in heifers. A total of 77 herds were included in this study and the potential animal- and farm-related risk factors were recorded during a one-time farm visit. The HMR was provided by the dairy herd improvement test (DHI) as the annual average of the past 11 DHIs. For this study, data were analyzed in two models using generalized linear models. Each model examined the association between possible risk factors and HMR, one including only prepartum risk factors and the other one only post-partum risk factors. One identified pre-partum risk factor was the proportion of udder-healthy cows in the herd. Post-partum risk factors were the type of teat cleaning procedure before milking, teat disinfection, treatment of mastitis in heifers, a body condition score (BCS) of >3.0 in fresh heifers, and the combination of a teat cleaning procedure with a teat disinfectant. The results show the importance of the period shortly after calving for udder health in heifers, as four of the five significant risk factors were identified in this period and three of them were related to the milking process. However, further research with a higher number of herds is needed to minimize individual herd effects.
During machine milking, pathogenic microorganisms can be transmitted from cow to cow through liners. Therefore, in Germany, a spray method for the intermediate disinfection of the milking cluster is often used for prevention. This method of cluster disinfection is easy to perform, requires little time and no extra materials, and the disinfection solution is safe from outside contamination in the spray bottle. Since no data on a systematic efficacy trial are available, the aim of this study was to determine the microbial reduction effect of intermediate disinfection. Therefore, laboratory and field trials were conducted. In both trials, two sprays of 0.85 mL per burst of different disinfectant solutions were sprayed into the contaminated liners. For sampling, a quantitative swabbing method using a modified wet–dry swab (WDS) technique based on DIN 10113-1: 1997-07 was applied. Thus, the effectiveness of disinfectants based on Peracetic Acid, Hydrogen Peroxide and Plasma-Activated Buffered Solution (PABS) was compared. In the laboratory trial, the inner surfaces of liners were contaminated with pure cultures of Escherichia (E.) coli, Staphylococcus (S.) aureus, Streptococcus (Sc.) uberis and Sc. agalactiae. The disinfection of the contaminated liners with the disinfectants resulted in a significant reduction in bacteria with values averaging 1 log for E. coli, 0.7 log for S. aureus, 0.7 log for Sc. uberis and 0.8 log for Sc. agalactiae. The highest reduction was obtained for contamination with E. coli (1.3 log) and Sc. uberis (0.8 log) when PABS was applied and for contamination with S. aureus (1.1 log) and Sc. agalactiae (1 log) when Peracetic Acid Solution (PAS) was used. Treatment with sterile water only led to an average reduction of 0.4 log. In the field trial, after the milking of 575 cows, the liners were disinfected and the total microorganism count from the liner surface was performed. The reduction was measured against an untreated liner within the cluster. Although a reduction in microorganisms was achieved in the field trial, it was not significant. When using PAS, a log reduction of 0.3 was achieved; when using PABS, a log reduction of 0.2 was obtained. The difference between the two disinfection methods was also not significant. Treatment with sterile water only led to a reduction of 0.1 log. The results show that spray disinfection under these circumstances does result in a reduction in the bacteria on the milking liner surface, but for effective disinfection a higher reduction would be preferred.
We report velocity-dependent internal energy distributions of nitric oxide molecules, NO, scattered off graphene supported on gold to further explore the dynamics of the collision process between NO radicals and graphene. These experiments were performed by directing a molecular beam of NO onto graphene in a surface-velocity map imaging setup, which allowed us to record internal energy distributions of the NO radicals as a function of their velocity. We do not observe bond formation but (1) major contributions from direct inelastic scattering and (2) a smaller trapping–desorption component where some physisorbed NO molecules have residence times on the order of microseconds. This is in agreement with our classical molecular dynamics simulations which also observe a small proportion of two- and multi-bounce collisions events but likewise a small proportion of NO radicals trapped at the surface for the entire length of the molecular dynamics simulations (a few picoseconds). Despite a collision energy of 0.31 eV, which would be sufficient to populate NO(v = 1), we do not detect vibrationally excited nitric oxide.
Although Corynebacterium spp. can be regularly associated with subclinical and clinical mastitis cases in dairy cows, knowledge on their reservoirs in dairy farms is sparse. Therefore, samples were collected at 10 visits with 14 day intervals from bedding material (n = 50), drinking troughs (n = 20), different walking areas (n = 60), cow brushes (n = 8), fly traps (n = 4), the passage to pasture (n = 9) as well as milking liners (n = 80) and milker gloves (n = 20) in one dairy cow farm. Additionally, quarter foremilk samples from all lactating cows (approximately 200) were collected at each visit. All samples underwent microbiological examination and cultured isolates were identified using MALDI-TOF MS. Most Corynebacterium spp. that were cultivated from milk were also isolated from the housing environment and milking-related niches (C. amycolatum, C. confusum, C. stationis, C. variabile, C. xerosis) or from milking-related niches only (C. frankenforstense, C. pilosum, C. suicordis). C. bovis was not cultivated from any environmental niche, while being the dominant species in milk samples. This study demonstrates that many Corynebacterium spp. present in milk samples can also be isolated from the cows’ environment. For C. bovis, the most relevant Corynebacterium species with regard to intramammary infections, it indicates that environmental reservoirs are of little relevance.
The aim of this cross-sectional study was to investigate the occurrence of bacteremia in severe mastitis cases of dairy cows. Milk and corresponding blood samples of 77 cases of severe mastitis were bacteriologically examined. All samples (milk and blood) were incubated aerobically and anaerobically to also investigate the role of obligate anaerobic microorganisms in addition to aerobic microorganisms in severe mastitis. Bacteremia occurred if identical bacterial strains were isolated from milk and blood samples of the same case. In addition, pathogen shedding was examined, and the data of animals and weather were collected to determine associated factors for the occurrence of bacteremia in severe mastitis. If Gram-negative bacteria were detected in milk samples, a Limulus test (detection of endotoxins) was also performed for corresponding blood samples without the growth of Gram-negative bacteria. In 74 cases (96.1%), microbial growth was detected in aerobically incubated milk samples. The most-frequently isolated bacteria in milk samples were Escherichia (E.) coli (48.9%), Streptococcus (S.) spp. (18.1%), and Klebsiella (K.) spp. (16%). Obligatory anaerobic microorganisms were not isolated. In 72 cases (93.5%) of the aerobically examined blood samples, microbial growth was detected. The most-frequently isolated pathogens in blood samples were non-aureus Staphylococci (NaS) (40.6%) and Bacillus spp. (12.3%). The Limulus test was positive for 60.5% of cases, which means a detection of endotoxins in most blood samples without the growth of Gram-negative bacteria. Bacteremia was confirmed in 12 cases (15.5%) for K. pneumoniae (5/12), E. coli (4/12), S. dysgalactiae (2/12), and S. uberis (1/12). The mortality rate (deceased or culled) was 66.6% for cases with bacteremia and 34.1% for cases without bacteremia. High pathogen shedding and high humidity were associated with the occurrence of bacteremia in severe mastitis.
In this paper a new rotor position observer for permanent magnet synchronous machines (PMSM) based on an Extended-Kalman-Filter (EKF) is presented. With this method, just one single EKF is sufficent to evaluate the position information from electromotive force (EMF) and anisotropy. Thus, the PMSM can be controlled for the entire speed range without a position sensor and without the need to switch or synchronize between different observers. The approach covers online estimation of permanent magnetic field and mechanical load. The resulting EKF-based rotor position estimator is embedded in the existing cascaded control concept of the PMSM without need of additional angle trackers or signal filters. The experimental validation for the position sensorless control shows optimized dynamic behaviour.
Antimicrobials are widely used to cure intramammary infections (IMI) in dairy cows during the dry period (DP). Nevertheless, the IMI cure is influenced by many factors and not all quarters benefit from antimicrobial dry cow treatment (DCT). To evaluate the true effect of antibiotic DCT compared to self-cure and the role of causative pathogens on the IMI cure, a retrospective cross-sectional study was performed. The analysis included 2987 quarters infected at dry-off (DO). Information on DCT, causative pathogens, somatic cell count, milk yield, amount of lactation, Body Condition Score, and season and year of DO were combined into categorical variables. A generalized linear mixed model with a random cow, farm and year effect and the binary outcome of bacteriological cure of IMI during the DP was conducted. In the final model, a significant effect (p < 0.05) on DP cure was seen for the DO season and the category of causative pathogens (categories being: Staphylococcus aureus, non-aureus staphylococci, streptococci, coliforms, ‘other Gram-negative bacteria’, ‘other Gram positive bacteria’, non-bacterial infections and mixed infections), while antibiotic DCT (vs. non-antibiotic DCT) only showed a significant effect in combination with the pathogen categories streptococci and ‘other Gram-positive bacteria’.
To effectively prevent and control bovine mastitis, farmers and their advisors need to take infection pathways and durations into account. Still, studies exploring both aspects through molecular epidemiology with sampling of entire dairy cow herds over longer periods are scarce. Therefore, quarter foremilk samples were collected at 14-d intervals from all lactating dairy cows (n = 263) over 18 wk in one commercial dairy herd. Quarters were considered infected with Staphylococcus aureus, Streptococcus uberis, or Streptococcus dysgalactiae when ≥100 cfu/mL of the respective pathogen was detected, or with Staphylococcus epidermidis or Staphylococcus haemolyticus when ≥500 cfu/mL of the respective pathogen was detected. All isolates of the mentioned species underwent randomly amplified polymorphic DNA (RAPD)-PCR to explore strain diversity and to distinguish ongoing from new infections. Survival analysis was used to estimate infection durations. Five different strains of Staph. aureus were isolated, and the most prevalent strain caused more than 80% of all Staph. aureus infections (n = 46). In contrast, 46 Staph. epidermidis and 69 Staph. haemolyticus strains were isolated, and none of these caused infections in more than 2 different quarters. The 3 most dominant strains of Strep. dysgalactiae (7 strains) and Strep. uberis (18 strains) caused 81% of 33 and 49% of 37 infections in total, respectively. The estimated median infection duration for Staph. aureus was 80 d, and that for Staph. epidermidis and Staph. haemolyticus was 28 and 22 d, respectively. The probability of remaining infected with Strep. dysgalactiae or Strep. uberis for more than 84 and 70 d was 58.7 and 53.5%, respectively. Staphylococcus epidermidis and Staph. haemolyticus were not transmitted contagiously and the average infection durations were short, which brings into question whether antimicrobial treatment of intramammary infections with these organisms is justified. In contrast, infections with the other 3 pathogens lasted longer and largely originated from contagious transmission.